Wall-mounted boiler water pressure sensor manufacturers: gas wall-mounted boiler safe use guide

boiler water pressure sensor manufacturers: as the temperature continues to drop, a new round of heating boom has begun. However, due to the low temperature in winter, problems abound about the failure of the boiler.

Wall-mounted boiler water pressure sensor manufacturers: use of wall-mounted boiler matters needing attention

1. The pointer of the water pressure gauge cannot be lower than the red warning line, and the normal use range of the water pressure of the heating system is between 0.5-1.5kg;

2. When there is no one in the house or when it is used for a long time, the antifreeze function of the wall-mounted boiler should be activated, or the water in the boiler should be drained to prevent the wall-mounted boiler from freezing due to low temperature. The specific measures are to close the gas valve, cut off the power supply, close the water supply, return water, Sheung Shui, valves, open the domestic hot water valve, supply valve, and discharge the water in the furnace;

3. The gas pipeline must not be wrapped up. In order to be beautiful, the pipeline must not be sealed in the cabinet. In case of gas leakage, the place where the gas is not distributed is prone to deflagration in case of open flame;

4. When the wall-mounted boiler is working, the temperature of the hot water outlet pipe and the bottom smoke pipe is high, and it is forbidden to touch it to avoid burns;

5. In the process of bathing, try to reduce the number of faucet switches, so as to save both water and-like;

6. It is not recommended to turn off the wall-mounted boiler when there is no one at work during the day. The temperature can be lowered to save more gas. Otherwise, it is relatively expensive to start operation after work;

7. Close or lower the radiator valve in the uninhabited room to save gas. Secondly, the room temperature rises rapidly during normal use;

8. It is necessary to ensure the smooth suction and exhaust of the smoke pipe of the wall-mounted boiler. When decorating a closed balcony or moving the machine, the suction and discharge ports of the smoke pipes must extend out of the window, and do not seal them indoors or use single-core pipes.

Wall-mounted boiler water pressure sensor manufacturer: five bans

1. It is strictly prohibited to use smokeless tube and single-tube wall-mounted boiler;

2. It is strictly forbidden to use braided hoses and hoses to connect water and gas paths;

3. It is strictly prohibited to block and use the safety relief valve to discharge water;

4. It is strictly prohibited to dismantle, disassemble and cover the main body and accessories of the wall-hung boiler without permission;

5. It is strictly prohibited to open fire leak detection.

boiler water pressure sensor manufacturers: how to protect the boiler and pipe

1, temporarily no heating, floor heating owners close the doors and windows in advance to prevent the indoor temperature is too low, freezing the radiator and piping system; After the first year of installation, if there is no heating and the temperature is lower than 0, drain the water in the floor heating pipe and apply air pressure;

2. Under normal circumstances, when the wall-mounted boiler is energized and ventilated, the wall-mounted boiler will automatically enter the antifreeze mode. When the water temperature of the wall-mounted boiler is lower than 8 degrees, the antifreeze protection function can only be started if the following four conditions are met: 1) the power supply of the wall-mounted boiler is turned on and cannot be cut off (the plug is not pulled out);2) Ensure the normal supply of gas (the battery of the gas meter is charged, the gas is sufficient, the pressure is normal, and the gas valve cannot be closed);3) Keep the water pressure of the wall-hung boiler at 1~1.5Bar (check; 4) Open the valve and connect the circulation pipeline; 5) The wall-mounted boiler is fault-free and can operate normally;

3. For users who normally use heating, it is recommended not to turn off the heating system when there is no one at home for a short time, but to reduce the heating temperature to maintain the indoor temperature at a certain level, avoid equipment damage, and protect other indoor wading equipment, Such as floor heating, radiators, etc;

Jiangmen Hengmin Intelligent Control Instrument Co., Ltd. is a pressure transmitter manufacturer, mainly engaged in oil pressure sensors, wall-mounted boiler water pressure sensors, urea pump pressure sensors, hydrogen pressure sensors, pressure calibrators, automobile pressure sensors, water pump pressure sensors, water pressure Sensors, intelligent pressure controllers, high pressure sensors and other products. Our company found in the research industry production activities that with the increasing popularity of the Internet of Things and intelligent manufacturing concepts, the demand for pressure sensors in my country has grown rapidly in recent years. In response to the needs of the era of intelligent manufacturing, our company has developed high-precision testing instruments and special production system equipment for pressure sensor manufacturers to help sensor manufacturers greatly reduce the labor intensity of testing, reduce the number of workers, improve product quality, improve production efficiency and reduce production costs.